Alcohol fireplace use detailed solution

Place the alcohol fireplace in a suitable horizontal installation tank, or the surface is flat, surrounded by 50cm range of non-flammable ground. Can not be installed in the surface is not flat, one end of the height of the table or the ground on the tilt, tilted single-sided before and after more than 15 degrees, the machine dump protection device will start, the machine boot alarm, will not start.

As shown in the figure: Insert the supplied power adapter, or the power cord, into a 110V-240V power outlet with a grounded 3-way ground. Plug the adapter output into the right-hand circular socket on the machine (if it is a power cord) Insert the machine side of the socket hole) machine can work standby standby, indoor AC power supply lines need to have leakage circuit breaker protection device (in the fireplace installed near the installation of fireplace control power switch). 

As shown in the figure: Open the fireplace on the panel door, you will see a plastic pipe mouth (internal machine power switch), connected to the random distribution of the hose, into the purchase of alcohol barrels, start filling switch, You can automatically extract the alcohol into the fireplace of the fuel tank (in the initial use of power on, the pump will automatically open the filling, if 25 minutes did not reach the fuel tank high water level, the machine will send an alarm and stop working) until All fill up automatically stop after the addition, and then hand pinch the root of the hose pulled out, pay attention to alcohol do not drip, otherwise, to wipe clean before you can use the ignition.

As shown in the figure: the right side of the machine has a white interface, such as in the early design of the design of external storage slot, please connect the random configuration hose can be connected to the random distribution of the hose, Into the external storage slot, start the filling switch, you can automatically extract the alcohol into the fireplace fuel tank (in the initial use of power on, the pump will automatically open the filling, if 25 minutes did not reach the fuel tank high water level .

The machine will be issued an alarm and stop working), until all filled with voice prompts that automatically stop adding, when the machine starts work, such as the machine internal storage tank fuel shortage, the machine will automatically replenish the combustion, as a result of this cycle , As long as the external storage tank of the fuel is full, can be used to start the cycle, this connector can be connected after a long time without artificial auxiliary alcohol. (We recommend that you use this interface function)