Water jet mosaic installation techniques

Water jet mosaic is now widely used in home decoration, it has a rich color, personalized pavement features, can bring a lot of wonderful for the whole room, and Water jet mosaic relatively small, pavement on the process requirements Very high, let us share the water jet mosaic is how to pave it!

Pavement Accessories:

General pavement tiles can be used with cement, but pavement mosaic is recommended with gluing agent. Because the density of mosaic is relatively high, low water absorption, cement adhesion effect is not good hook, pavement can not guarantee the stability of the mosaic.

Check the details:

To be Water jet mosaic all the wall paving finished, the adhesive layer after the final condensate, after the completion of the hook, and then do a check, will be left in the seam of the floating sand can be used clean and wet soft brush gently out, Rice crack bar points to use 1: 1 cement mortar hook gouge, and then wipe the cloth. When the adhesive layer and paste the mortar after the final finish cleaning.

Do a good job:

Water jet mosaic Paving is completed, pay attention to the protection of finished products, can be properly dried. In the newly laid surface should avoid sun exposure, the room should be properly ventilated, has been maintained until the 24 hours after the transfer, the general post-mortar mosaic maintenance should be no less than 7 days.

Clean:

After the end of the adhesive layer and the mortar mortar, you can start cleaning the Water jet mosaic surface. Cleaning work need to prepare two barrels, a new cleaning agent, a clean water, first installed in the detergent inside the bucket wet wipe, do not wring dry, and then circularly wipe the way Water jet mosaic surface: The second is filled with a clean bucket soaked sponge, and then sponge rub the surface of the mosaic, wipe all the residue.

Finally, once again with a sponge to clean the surface until the clean so far.